Simple AA Battery (x4) Holder

I needed a case to carry spare AA batteries in my camera bag. I know there are probably dozens, if not hundreds here, but... I like reinventing the wheel :)

NOTE Due to either a Thingiverse bug or (more likely) shadowbanning, my models no longer show up under the [Newest] listings. If you want to see more of my models, please be sure to 'follow' me.

Another Sketchup Model - Debunking the Myth that Sketchup is Useless in 3D Printing

Print Settings

Printer Brand:

TEVO

Printer:

Tarantula

Supports:

No

Resolution:

0.2mm

Infill:

20%

Post-Printing

Depending on your printer's tolerances, you might have to sand the upper section of the bottom piece where the two halves come together.

Straight out of my printer, the lid when on nice, but at the very end of travel, it snapped in place and was apain to get back off. A few passes of 80 grit sandpaper and now it's a nice snug fit, but not too snug.