Little Miss Chevious

This is not my model. I downloaded this a long time ago from Thingiverse and only just now got around to printing and painting her. I wanted to share this model and my paint job, but the original has since been 404'd down the memory hole. I have searched for the creator of this model and I cannot find him/her or it (the model) anywhere. So, in accordance with the original license, I am uploading this here.

I did fix the files so that they are manifold, though. There are still a couple of issues that I saw with the print, even after fixing the files.

• Make sure that you print with "Print Thin Walls" enabled. There are spots on her jacket that will not print otherwise.
• The original modeler extruded the teeth and the eye on one side and then inset them on the other. I think s/he was mirroring the operation, but the mirror must have been set to invert? I don't know. As long as you only look at one side at once, it's ok, though.
• The hand resting on the bomb doesn't exactly rest on the bomb when everything is glued together. It kind of hovers a couple of millimeters off the surface. I don't know if this is because of how I printed or assembled everything, so I didn't bother trying to "fix" that in the fie when it might not be a model issue. What I did was kind of create a wrist with a 3d pen, some files and some sandpaper. Your mileage may vary.

The original text of this upload is as follows:

http://www.thingiverse.com/thing:3459051 Little miss chevious by 3DJUNKIEZ is licensed under the Creative Commons - Attribution license. http://creativecommons.org/licenses/by/3.0/

Summary

This is a model who iv called Little miss chevious based on a pinup girl. iv split and keyed her so is ready to print. more over on my group 3DJUNKIEZ

Print Settings

Printer Brand:

TEVO

Printer:

Tarantula

Rafts:

No

Supports:

Yes

Resolution:

0.1mm

Infill:

10-40%

Notes:

I used 40% infill in the bomb to add weight. The rest o f the model is printed at 10-15% infill.