Anet A8 power switch box

I was looking for power supply covers, but didn't want to spend an hour or two to print the ones i found, and wasn't worried about sticking my fingers near the power supply and getting shocked... cause I'm not a complete retard. I made this to fit in the slotted holes on the power supply side of the Anet A8. The brace slides over the housing and bolts on the back side of the frame sandwiching it in and making it sturdier ( it may or may not be needed, but i wanted to take some pressure off the front bracket). Remember ... Always solder your connections when ever possible, DO NOT trust crimp on terminals.

P.S. i even included pictures on how to wire the switch and the power supply ( in case you forgot :D )

Print instructions

Unassociated tags: anet a8, power switch, switch housing

Category: 3D Printer Accessories Print Settings

Printer: Anet A8

Rafts: No

Supports: No

Resolution: 0.2mm

Infill: 20%

Switch

From Amazon:

https://amzn.to/2AX6yLU