Sonicare Brush Marker Clips (Philips)

OK, have you ever wondered why Philips Sonicare toothbrushes come only with the same four cheesy "colors" as their marker rings?
What about if you are a family of five or more? What about if you want to use a different brush head for each day of the week? What about .... whatever!

I designed those clips that you can print in different colors and then attach to your toothbrush head in order to mark it in any colorful way you want to.
To clip it on, start right below the brush where the stem is very slender. Then pull it down.
Clips are slightly asymmetric and have their smaller side on top to adjust to the tooth brush form.

The "clip storage thing" in the last photo is another one of my designs.
You can download it on Thingiverse: Ring Object Storage - Dispenser

BTW: This is my 20th design that I uploaded to Thingiverse.

It may look like I'm a bit obsessed with Philips devices, especially with their Sonicare/Sensonic electric toothbrush line; and in fact I like their product(s) - a lot.
However, think about it: If the company would do an even better job designing their stuff in a more thoughtful way, I wouldn't have to pimp it like I do!!

Have fun, enjoy and let me know when you made one or two or seven of it!

Print instructions

Category: Bathroom Print Settings

Printer Brand: TEVO

Printer: Tarantula

Rafts: Yes

Supports: No

Resolution: 0.1mm

Infill: 100%

Notes:

Print it with 0.1mm layer height and probably with a raft/brim due to the small bottom part.

I keep the gcode for this (4 of them) on my printer's SDCARD, so whenever I put up a colorful roll of filament, I print a few clips... just to have them ready when the kids ask for it! :-)