Delta PSU (black) Prusa MK3S Lack Enclosure parts

The Prusa MK3S is now shipping with an all new black power supply. This power supply has slightly different dimensions than the previous one. In order to relocate the power supply out of the LACK enclosure to the lower table we can no longer rely on just the parts listed here:

https://www.thingiverse.com/thing:2864118/

These parts complement the above project so that the black power supply can be relocated.

As a bonus, a funnel shaped low strain filament pass through grommet has been added.

I want to acknowledge a few designs that I used for inspiration: I used the original PSU cover part included with the printer and designed a copy of this with the addition of the mating part that joins the table mounted hook. Also, the hook is a direct copy of the original one for the lack enclosure project shown above. Therefore, anyone who is upgrading their PSU from the old silver one could potentially reuse their existing hook.

Finally I want to mention a few other projects that I looked for inspiration:

https://www.thingiverse.com/thing:3553216 is essentially the same as the power supply support in my design with one exception: The one on my design is 106mm wide because I believe the power supply at 105mm requires 1mm of tolerance so the fit is not too tight after parts shrink due to cool down.

My design is tested and all parts fit effortlessly.

Print in PETG at 0.2mm layer height

Print instructions

Category: 3D Printer Accessories Print Settings

Printer Brand: MK3

Printer: Prusa i3

Rafts: No

Supports: No

Resolution: 0.2mm

Infill: 20%

Filament: generic PETG black