Handlebar Bag Cradle

I made this as an alternative to the more expensive handlebar cradles that are out there. I designed it around this bar extender on amazon: https://www.amazon.com/gp/product/B07FD5DLG9/ref=ppx_yo_dt_b_search_asin_title. The only other things you need are a dry bag somewhere around 6 inches in diameter and some velcro straps to hold everything in place. It's been through a couple trips already and held up great! Print with support, 15-20% infill, and preferably using PETG. Other filaments will probably be fine as well though.

It's dimensions are in inches so in you're slicer you'll have to either switch to inches or size it up by 2540% to match millimeters. If you're printing in PrusaSlicer, I used the .2mm Quality settings for PETG and just made sure supports were enabled and it came out great. Took about 20 hours to print though!