Dog puzzle toy - may 2026

Model

The model consists of 15 parts:

1. circular base

2. circular lid

3. linear drawer (4x)

4. swivel drawer (4x)

5. M3x12 hex socket screws (5x)

Printing parameters

I printed all parts in PLA with the following parameters in Prusa Slicer:

• 0.2mm layer height

• 20% grid infill

• Contour shells top: 5, bottom: 3, vertical: 2

• 5mm brim recommended for better adhesion (especially for lid and base)

Important note: For better durability of the pins in the model, I printed them with 60% infill (grid). The infill should extend several millimeters into the base or handle and slider. See pictures for reference.

Happy printing and puzzling!