Raspberry Pi Camera V2 Snapmaker 2 Toolhead Mount

A mount to attach your raspberry pi v2 camera to the toolhead of your Snapmaker.

This allows you to aim the camera directly at the extruder nozzle so you can closely inspect layers as they go down to ensure no problems.

Mounting hardware (All came in this kit):

• To replace the toolhead screws
  • 4 M2x6
• For the toolhead mount <> horizontal arm
  • 1 M2x10 screw
  • 1 M2 nut
• For the horizontal arm <> sliding mount
  • 2 M2x8 screws
  • 2 M2 nuts
  • 2 M2 washers
• For the sliding arm <> vertical arm
  • 1 M2x14 screws
• For vertical arm <> pi camera v2
  • 4 (or 2 if you're lazy) M2x4 screws
  • You might wants nuts too (again, if you're not lazy)

NOTE: I messed up a bit on the dimensions, so the vertical arm must attach to the toolhead mount one rung "up" from where it was originally designed. I moved the object up in the f3z file though so you can see what to do.If you mount it in the original designed location, the camera will probably run into your prints if it's able to see the extruder nozzle. (all the shots below have it in the right position though)

Print Settings

Printer:

Snapmaker A350

Rafts:

Supports:

Yes

Resolution:

Infill:

.4 mm

Filament:

Snapmaker PLA

Black

Notes:

Post-Printing =============

Elephant foot cleaning

How I Designed This ===================

General process

Custom Section ==============

Note how the horizontal arm joins to the toolhead mount one rung up.

from above

from below

side view

View you can see when printing (in octoprint), you'll want to make sure to print a focus tool (I like https://www.thingiverse.com/thing:2241293) to focus the camera since it'll definitely be set too far

Category: 3D Printer Parts