Microphone stand v2

A minimalist table stand for your microphone.

This version has the same interface as the original version. The base is slightly larger and perhaps better looking.

Print Settings

Printer Brand:

Ultimaker

Printer: 

Ultimaker Original

Rafts:

No

Supports: 

No

Post-Printing

Print the foot, screw the microphone stand adapter that hopefully came with your microphone on it, and insert your microphone. If the adapter is height adjustable, so is your microphone.

The foot doesn't have printed threads; The threads on the adapter are supposed cut into the bolt on the foot (which has a diameter of 15.5 mm), forming its own threads.

How I Designed This

This thing is designed to be simple, easy to print, and give good results with a variety of print settings.

• Zero overhangs.
• Rounded perimeter helps prevent lifting corners.
• The print only has one island (or no islands, if you will), except for a few layers in the middle where there are two. This means fewer retractions.
• Can be printed solid without using a ton of material. (Can also be printed with thick walls and/or high infill, depending on what properties you want.)

Bill of materials

• PLA: 18 g
• Microphone stand adapter, ⅝″ 27 threads per inch (tpi) Unified Straight thread
• Microphone

Category: Music