PSU Cover

PSU COVER 3D PRINTER

Shamelessly cloned from Tevo Tarantula PSU Cover, but made from scratch. 3D files attached, if someone wants to remix again.

NEEDED PARTS

• 3x XT60 connectors
• 1x IEC 320 C14 Red Light Rocker Switch Fuse Inlet Male Connector Plug

INSTRUCTIONS

1. The 3 pin plug needs two M4 screws of at least 6-8 mm long and 2 nuts.
2. The slot for the TX60 connectors is tight enough to hold them in place but just in case I superglued them to the walls.
3. To hold the cover in place screw 3x M4 screws through the hole on the left/right sides to the hole on the PSU.

Print Settings

Printer:

JGAurora A5s

Rafts:

No

Supports:

Yes

Resolution:

0.2

Infill:

20%

Filament:

Yellow