EcoFlow WAVE 2 / 3 Duct Connector Caps

Special thanks to Kraemer for his original work. I'm using his connectors in a conversion trailer, where my ducting ports run through the floor. Since those holes are permanent, I needed a way to cap them off when they’re not in use.

I sliced these parts in PrusaSlicer and printed them using PLA. No special settings were required, though I couldn’t avoid using supports. I found that orienting the part with the twist handle facing down on the build plate produced the best results. I used “Snug” style supports and painted them onto the overhangs (13°). See the included screenshot. The three slots were easy to clean up afterward with a utility knife.

This model is intended to be used with Kraemer's 5" and 6" EcoFlow WAVE 2/3 duct connectors.