Stand for 13"/14" Notebooks

The both side parts should be printed with a filament that can resist higher temperatures. I made good experience with PETG. The pads should be printed with TPU.

To mount the two parts together, two rods with a diameter of 8mm and 250mm length are required. I used simple aluminium rods. The pads I glued with double sided tape.

Optionally, four pads with a diameter of up to 28mm can be used as feet by glueing them beneath the stands.

The rough dimensions of the stand are:

• ~165mm in height
• ~267mm in width

I printed the stand in PETG with a 0.6mm nozzle, 5 perimeters, 0.3mm layer height, and 25% infill.