4 channel relay mounting cage for Top Hat DIN Rail / Cap Rail / Hutschiene 35mm / Arduino

This is a bare holder to mount a 4 channel relay on so it stands level on the table without the risk of short circuit.

You can use my Top Hat Rail / Cap Rail mount base plate to easily mount your relay into your control cabinet.

There are two versions of the holder:

• One with a flat base for simple table stand or for glue to the flat Cap Rail mount base plate

• One with clips to snap on the version of my Cap Rail mount that has notches
  Thread the holes with M3 thread cutter before mounting the Pi on it.

  The distance of the mounting holes are 38mm x 68.3mm

  Hint: The clips snaps really tight on the notches of the Cap Rail mount. I carefully bent the clips a little bit before putting these two together. You have to use quite a lot force to snap them together. But the PLA I used for printing was flexible enough. Once snapped together it is not designed to be put apart again.

  Have fun with it :)