Raspberry Pi 2 B+ mounting cage for Top Hat DIN Rail / Cap Rail / Hutschiene 35mm

This is a bare holder to mount your Raspberry Pi B+/2 on so it stands level on the table even with mounted heatsink on the bottom.

You can use my Top Hat Rail / Cap Rail mount base plate to easily mount your Raspberry Pi into your control cabinet.

There are two versions of the holder:

• One with a flat base for simple table stand or for glue to the flat Cap Rail mount base plate

• One with clips to snap on the version of my Cap Rail mount that has notches
  Thread the holes with M2.6 thread cutter before mounting the Pi on it.

  Hint: The clips snaps really tight on the notches of the Cap Rail mount. I carefully bent the clips a little bit before putting these two together. You have to use quite a lot force to snap them together. But the PLA I used for printing was flexible enough. Once snapped together it is not designed to be put apart again.

  Have fun with it :)

Print instructions

Category: Electronics