PSU Silver > Black conversion Brace

If you need to remove previous "silver" PSU and replacing with new "black" (Delta) one, you will find that you have to remove slide-nuts from top horizontal gap to side gap of printer frame X profile...

• that needs serious work on printer, and if you are lazy like me or just can't spare time to do so at the moment, maybe this modified brace (original by Mikolas Zuza) will come handy.

This mount leaves PSU unit with small gap apart from printer frame, it will be probably not so perfectly horizontal/vertical positioned in general but holds well.

Print instructions

PLA worked fine for me, 0.2 layer, no support, no raft/brim.
You will need usual 2x M4 nut (stays same as for original brace) - this is not in spares, so you need extra two.
2pcs M3x10 you use to screw it into profile - as removed from silver PSU,
(spare) 2pcs M3x10 + 2pcs M3ns for hang screws
(spare) 1pc M3 x10 screw to screw in hole into PSU through brace in the middle of flat side