Printed with PETG, 0,2 layer height. No supports. Took about 12 hours on my Prusa Mini. Thanks for designing this 😊🙏
RD6006 case
This is a case for the RD6006 variable voltage regulator.
27
384
3
2856
updated January 5, 2020
Makes
Comments
Worked perfect for me
Printed without supports Great Job
Printed with PETG at 0.15mm with no supports or my Mini, came out perfect!
Wow , it turned out Amazing without support at all. here is my setting :
- 0.3 MM layer
- 35 % Infill
- i used nGen filament (great for over hang). (edited)
Super glad to hear that, did you use supports inside? (edited)
jep, for some odd reasons do the pictures always upload on the side. sorry for that (edited)
(deleted)