Diamond pattern for fabrics

This 3D model is designed to be attached to fabric (e.g., T-shirts, handbags, etc.). 

The pattern is determined by the printing plate. You will need tulle fabric that matches the color of the fabric to which it will be attached. 

Print the model until approximately 70% is complete, then pause and place the tulle fabric onto the model. Secure the fabric by attaching magnets to the print bed at each corner so that the tulle fabric cannot move. The magnets must be low enough so they don’t collide with the toolhead. Then continue printing. You can sew the finished model onto fabric.

Have fun!

 Disclaimer: Wash by hand only and do not use a dryer.