Tall Shelf Case

This is an addition to the original “Bookshelf and Cupboard” by narnaa found on thingiverse. https://www.thingiverse.com/thing:4702287

I Extended the original bookshelf design to accommodate another shelf. The regular shelf was a bit short in certain circumstances for example next to an upright piano in a tavern so I extended the original design for this purpose. Added an extra mirrored version of one of the original shelves to add variety it's not from scratch but breaks up the look a bit for a more natural shelf.

Printer:

Prusa Mini+

Rafts:

Recommended

Supports:

No

Resolution:

0.05mm* (look in printer notes)

Infill:

15%

Filament brand:

Prusament

Filament color:

Gentleman's Gray

Filament material:

PLA

Printing Notes:

I printed it fine the first time without rafts but had problems with sticking to the bed after that so a raft would be useful.

I've also gotten the advice to slow down the speed to 40mm/s to help with the stringing issue but I haven't reprinted it because it is close enough for me and my friends and to set up small environments so it is good enough for the moment, but if you are more serious about the look of it, then it seems like sound advice. 

*I also got the advice of Printing it in layer height of multiples of 4 (i.e., .04, .08, .12, .16, .2, etc) but I don't yet understand that.

Expanded the Shelf to add another layer