Rubic's Johnson

Years ago Angus (Makers Muse) made a rubic's cube shaped like a pineapple, and provided instructions on how to do it. So here is my version. A rubic's cube using Dwayne “the Rock” Johnsons head. Can you unscramble the Rocks head. 

You will need  to print the core piece. You will need 6 3mm screws, 6 3mm nuts, and 6 short sections of spring. To get the springs take 3 ball point pens, remove the springs and cut them in half. 

Place the nuts inside the core. Start with the bottom center section. Place a spring on a screw, run it threw the bottom piece and thread it into the core piece. than place the remaining bottom pieces around the center piece. 

For the middle section attach the 4 center pieces to the core using 4 of the 3mm screws and spring sections. Place the remaining 4 middle layer pieces in place. Finish off with the 9 top pieces. 

Congratulations you now have a Rubic's Johnson you can scramble at will.