Snap-Fit Cable Management Clips for Articulating Raspberry Pi Camera Mount

Tired of using permanent zip ties to manage your camera cables? These snap-fit clips are a completely original solution designed to tidy up your articulating camera arm while keeping it easy to adjust or disassemble.

They are designed to click directly into the rectangular zip-tie openings found on the standard and normalized links.

Key Features:

• Tool-less Installation: Just snap them in. No zip ties to cut, no waste, and no scratching your fingers on sharp plastic ends.

• Reusable: Easily pop them off if you need to reroute your cable or change your arm configuration.

• Secure Hold: Perfect for the standard thin cables found on Raspberry Pi cameras and webcams.

• Multiple Variants: I’ve included several styles (open loops and closed hooks) so you can choose the one that works best for your cable thickness.

Print Settings:

• Material: PETG is highly recommended for these because it is more flexible and less likely to snap during installation than PLA.

• Orientation: Print them flat on the bed for maximum clip strength.

• Layer Height: 0.20mm works perfectly.

• Supports: None required!

Designed for:

Other models in collection: