Adjustable Picatinny Nerf Sights

Requires only 3 (EA) M3 nuts and bolts. Also optionally requires a small amount of super glue. 

1. Print in orientation as imported into slicer, with supports touching build plate enabled. 
2. Adjustable rear sight is assembled in the same fashion of the original file set. 
3. Install front reticle by inserting a contrasting color of 1.75mm filament and trimming the excess. Super glue is optionally used to fix the reticle in place.

Front sight is elevation adjusted. Tested on a 150FPS blaster at typical Nerf engagement distances. Rear sight (Windage) may be adjusted utilizing the knob. 

Bonus: Faux red dot (RDS)/reflex sight and mount. Installs with 2 (EA) M3 nuts and bolts. Print as imported, no supports required. 

Minimized/simplified remix.