Prusa Mini Thumb Tabs - Smaller Remix

I liked the idea of having a small handle to move the heatbed without touching the sheet of the bed.
But saw that some users had issues with the printing on the side of the original thumb tab.

So I wanted just one position to grab the bed with, a short printing time and easy printing.

The remix can be printed on one of it´s sides and should be done with PETG. 

If you add it to you slicer, you can rotate it by -26,549 degrees on Z-axis to align it to your Y-axis or just use the pre-sliced gcode.

Printed with 0,2mm layer height in about 88 minutes.

To fix it to the Y-carriage you need two M3 nuts, I´ve also used two M3x10 screws. 
Also compatible with the silicon mod instead of the heatbed metal spacers.