Plotter addon for FDM 3D Printer

Plotter addon for FDM 3D Printer, designed for low wearing of the Z axis.
1
9
1
181
updated April 5, 2022

Description

PDF

Plotter addon for FDM 3D Printer

Pen plotter addon for FDM 3D printer. Made in Freecad, sources included.

It is easily mounted on the side of the 40 mm layer fan and can be left permanently installed.

You will need some smooth 4mm in diameter shaft cut to length (two pieces). I used aluminum but other materials such as PVC, steel, carbon fiber, etc. can be used. The shafts can be pressed in, no glue needed.

It uses a standard SG90 miniservo. You can find wether your printer has free pins and activate one for the servo in Marlin.

You also will need a short 2 mm in diameter screw for the connecting rod, and standard screws to mount the servo, and its arm to the connecting rod.

The pen holder is a small piece that you can easily interchange for different pen sizes. It has a captive screw to keep the pen in place, to which you can make a groove so it is at the same height in every plot. Probably you'll need to file the shaft holes in this part a bit until it runs smoothly.

There are two sizes of holder for the pen: 4 and 12 mm.

-- Print Settings --

Print all parts in the orientation they are when you load them.

0.15 mm layer height is OK for all parts (0.2 mm for the first layer)

Part 1 - The support base: This part can be printed with standard 20% infill. No supports, 7 layers top, 7 layers bottom, 3 vertical shells. Print a skirt if you want, but no brim is needed.

Part 2 - The pen holder: 20% infill, No supports, 3 bottom and top layers, 2 vertical shells, bridges activated, brim of 12 mm at least (otherwise it can pop out of the build plate)

Part 3 - The servo arm (connecting rod): It is important to print it with 100% infill. This part DOES require supports. No brim.
 

Tags



Model origin

The author hasn't provided the model origin yet.

License


Highlighted models from creator

View more