Creality CR-6 daughterboard mount

Introduction

This daughterboard is part of a series to enable mounting different extruders and hotends directly to the Creality CR-6 strain gauge. When mounting the extruders and hotend the original daughterboard mount does not fit any longer. Hence this replacement.

Accessories

The mount uses 2 M3 x 3mm hot melt inserts.

Alternatively the daughterboard can be mounted using 2 nuts instead of the hotmelts.

Printing:

Print settings are not very critical. Supports are needed.

A high temperature filament like PETG, ABS, ASA or other are preferred. PLA will however work as well as the part sits far enough away from the hotend and warm parts of the extruder motor.