Star Wars Republic Commando DC-15s Blaster Pistol

Hey folks,

This is a repaired and remeshed version of Panderazo's DC-15s pistol. I've made the following modifications:

• Joined small triangles
• Englarged the inside diameter of the barrel and made it 190mm deep to fix the mesh clipping issue inside the barrel
• Filled in divots on the left side of the weapon by the fins and barrel base
• Other small changes to make delta printer friendly.

This is still a WIP. If you don't have a tall printer you will likely need to split the model. This is my first repair and remesh job I'm sharing out to the community, so please let me know if there are obvious issues here! It printed pretty well on my Rostock, but I will be making another with some profile changes in place for PETG.

Also,this gun is huge! It's Desert Eagle huge. Which is awesome, and accurate, but if you have tiny hands I recommend resizing down to 90-95%!

Haven't refinished yet, but here are some pictures of the raw model!

Print Settings

Printer Brand:

SeeMeCNC

Printer:

Rostock Max v3.2

Rafts:

Yes

Supports:

Yes

Resolution:

.5mm

Infill:

20%

Filament: Atomic PETG Black

Notes:

You'll need a pretty well calibrated printer for this print, it's a little tricky. I printed with the barrel pointing straight upward, with supports for any angle over 60 degrees, and a raft on the buildplate. A good portion of the 'back' of the pistol will be printed on the supports, so depending on your settings you will need to do some postprocessing. The folding stock will also be tricky as well, make sure you go slowly when removing your supports around it.