12mm OD Acrylic Cutting Jig

Hey folks,

This is a simple acrylic tube cutting jig I threw together after not being able to find one. I made it so I could safely cut my watercooling tubes with a small hacksaw without needing to buy an expensive kit. My printer is pretty dialed in geometry wise, if yours is not you may need to increase side by 1-2% as the fit is intentionally snug. The tube slides in from either direction, and there's a small 1mm cutting channel for your saw blade. I made the base flat and extended so you can mount to a desk or a piece of wood or something. Enjoy!

Print Settings

Printer Brand:

SeeMeCNC

Printer:

Rostock Max v3.2

Rafts:

No

Supports:

No

Infill:

60

Filament:

Red

Notes:

Printed with 5 top, bottom, and side layers, 60% infill.