PrusaBox Enclosure - Horizontal Mount for Logitech C920 Camera

This is a changed design to my original vertical mount for a Logitech C920 which allows mounting the camera without removing the factory mount from the camera.  The original mount was vertical which works ok, but it can vibrate a bit when the printer is really active.  Actually with the original design, this could be minimized or stopped by resting the bottom of the vertical mount to the top of the wire wrap mount.

This horizontal mount allows the factory mount to slide into horizontally to the custom mount so that the camera can be pushed back farther from the printer than the original design, and also the center of gravity of the camera now is almost below where the mount attaches to the rail so this design is steadier than the original.  The housing can swivel from side to side.

There is also an optional mount that can be used to tie up excess cable.

The parts need to be rotated as shown in the last picture for printing