Hi everyone.
I share here my solution to provide some wind protection for the Kawasaki Z750S. As you may have already found out if you arrive here, getting handguards it's difficult, most of them don't fit properly. And if you are like me and like to ride as much as possible, wind protection and hand warmers are more than welcome.
I recommend adding extra perimeters, 5 or 6 is the best. Infill in general does not help that much, 20% is enough.
I printed it in PLA because I found it in the same color as the bike, but in theory, PETG should perform better.
I also turned the head of some stainless steel screws, just because the old ones looked a bit rusted already. But the original ones should be long enough.
I hope someone finds this usefull.
The author hasn't provided the model origin yet.
