(REV2) ENDER 3 V2 - Raspberry Pi zero 2W case and PiCam mount

This is a remix of three models

Camera bracket:

https://www.printables.com/en/model/157687-ender-3-v2-gantry-adjustable-pi-camera-bracket

Case:

https://www.thingiverse.com/thing:1167846

Camera bracket mount:

https://www.printables.com/cs/model/30752-ender-3-x-pulley-cover

This model is for ENDER 3V2.
It allows you to use a pi camera with an RPI zero 2w (I believe no one sells zero edition cables longer than 30cm).
I'm using PiCam version 1, but the design should be compatible with version 2.

Compatible with BL Touch and other variants. Both revisions make enough space for it. (they do not interfere with reaching the endstop)

REV2:

This revision makes it simple to mount the entire system. 




 

REV1:

edits:

 I modified the arm and made the Backplate "ball" smaller. 

For simplicity of installation, I provided recessed holes into which M3 nuts could be installed.
Because the fit is so tight, you'll want to make sure your printer is set to maximum dimensional accuracy.

The bracket was installed with 12mm M3 socket cap bolts. 

SirNut

I just used electrical tape to keep it in place.
That, I believe, is sufficient.