The Luftwaffle

Look out! It's the Luftwaffle!

My username is a pun about waffles and the German air force (Luftwaffe), figured I should bring that to life!

This is a model of the German BF109 fighter, with a silly waffle texture added.

The seams of the assembly are aligned with the waffle texture, so with a clean print they should be very well hidden.

You will most likely need supports for the tail unless you use a very small layer height.

Holes are present in each fuselage piece to use 1.75mm filament to join the pieces together, but I recommend using glue as well. The propellor clips into place (depending on the quality of the print the clip may need to be sanded a little). I attached the wheels using M3 bolts, but you could probably just glue them in place, they don't really roll much.

I hope you enjoy this silly little joke :)