Fake Medieval Book Case

INSTRUCTIONS

Book Cover Top MC KCD LOGO

• printed as a multi colour first layer

  • if your printer cannot print multi colour look up tutorials for single extruder multi colour printing on YT or print as 2 separate files, just make sure bed leveling is off for the second colour and your z lift is greater than 0.2mm

  • ensure both filaments used are the same as PLA does not stick to PETG

• designed for a 0.2mm layer height (only first layer needs to be 0.2mm, other layers can be larger/smaller)

• a textured PEI or similar bed is recommended for a more natural look

Book Cover Bottom

• Printed in a single colour (matching the main top cover colour)

• supports on

  • "everywhere" setting on (any marring to the bottom surface of the cover will be covered by the pages during assembly)

Pages Divided

• Print in a white (of similar) filament

• use a large layer height to achieve the appearance of pages

  • 0.3 or higher recommended depending on your nozzle size

Assembly

• the pages are glued onto the bottom cover with whatever glue works for you

  • there is a slight counter sink in the bottom cover to ensure alignment

• the top and bottom covers are connected using a filament hinge

  • clean up the hinge holes as needed with a small diameter drill bit

  • push a length of filament into these holes while aligned

    • it may be difficult to push a single length of filament in one go so using 2 (one from each side) will work as well

  • trim ends off of filament hinge 

• and voila! you're done!

NOTES:

• a blank cover STL is also included if you want to design your own cover art

• a STL of the pages without the dividers is also included