1:10 Scale Modular Armwrestling Table Miniature

This is a functional 1:10 scale miniature of a professional armwrestling table, designed specifically for fans of the sport and collectors.

Most miniatures force you to choose a side, but I designed this one with a modular "plug-and-play" system.
Both the pin pads and the elbow pads are completely removable, allowing you to switch the table layout from Right-Hand to Left-Hand configuration in seconds.

What’s included:

1x Left Half Table Top Frame
1x Right Half Table Top Frame
2x Elbow Pads
2x Pin Pads
2x Hand Pegs
4x Legs
1x Base For Legs

I’ve designed this to be a straightforward print, but here are a few tips to get the best fit:

• Print the Base and the two Half-Frames as you normally would. They are designed for standard tolerances.

• If you find the pins or hand pegs are a little too loose (or too tight) on your specific printer, you don't need to resize the whole model. Just adjust your "Hole Horizontal Expansion" (in Cura) or "XY Hole Compensation" (in PrusaSlicer/Bambu Studio).

Pro-tip: A tiny adjustment of 0.05mm to 0.1mm is usually all it takes to get that perfect "click" fit for the interchangeable pads.

Layer Height: I recommend 0.12mm or 0.16mm for the pads and pegs to keep the surfaces smooth and the swap-system working flawlessly.