QIDI Q2 Top Spool Holder

Top mounted filament spool holder for printing soft TPU on QIDI Q2.

Can be used without removing QIDI Box.

Uses spool axle design from Cell Spool Winder.

Parts needed:

• 1x Axle.stl from this design (mind the bearing size).

• 2x Side.stl from this design (mind the bearing size)

• Axis drive 01.stl and Axis drive 02.stl from Cell Spool Winder

• 2x bearings

Print settings:

• Side.stl - see recommendations for original model for side part

• Axle.stl - see Cell Spool Winder recommendations for shafts

• Axis drive 01.stl and Axis drive 02.stl - see corresponding Cell Spool Winder recommendations

Supported bearing types:

• 6202 - 15 mm ID x 35 mm OD x 11 mm wide

• 6082 - 8 mm ID x 22 mm OD x 7 mm wide (not tested yet)

Tell me if you need a variant for a different bearing size.

Adapted for QIDI Q2 printer.

Spool axis design from Cell Spool Winder