Star Wars Imperial Cog iPhone 16e Case

******I haven't printed this yet. Will update pictures after I do*******

I designed this to fit my iPhone 16e with a built in credit card holder on the back. The card holder holds 3 cards firmly. I have a version to hold 2 cards available.

If you want to change colors for the holder and/or logos then change at 13 mm.

I added built in supports, so DO NOT enable supports in the slicer. For some reason after an update, I couldn't get PrusaSlicer to put in supports unless I painted them on. It was a real hassle, so I just added some. There is a .2mm gap between the top of the support walls and the start of the roof. They do a great job, so the first layer of the roof is pretty clean (see picture). They tear off very easily with pliers. Honestly, they use less material, are easier to remove, and do as good a job as slicer added supports.

I included a thin layer in the design with a gap above and below so it doesn't stick to the top or bottom of the card holder. Before removing from the build plate, use a scraper above and below that piece to loosen it. Then, you can use pliers to pull it out. You can put the insert back in if you only want to hold one card.

Also Available: 
--Imperial Cog 2 and 3 Card Holder
--Rebel Symbol 2 and 3 Card Holder
--SpaceX 2 and 3 Card Holder
--All the above for iPhone 12 Pro
--All the above without a credit card holder