5/8 PVC Tee Connector

This is a simple 5/8" Tee made to join two pieces of 5/8" PVC together.

It’s meant for 5/8" outer diameter PVC (0.625"). The fit should be snug enough to hold well, but still slide on without needing to fight it (depending on your printer tolerances).

Good for:

• DIY frames

• Hobby builds

• Prototypes

• Random projects where you just need a clean T joint

The body is thickened a bit around the center so it doesn’t crack at the joint, since that’s usually the weak point. Overall it’s just a solid, simple connector that does exactly what it’s supposed to do. If you are printing with PLA or PETG, please message me for a thickened model.

If you need a model in-between the small and medium or in-between the medium and large, please message me and give me measurements.

ABS is recommended for this print.