T-Nut Clamp Set and Case

T-nut clamp set with case

Print instructions

Printed using Hatchbox PLA. Toe clamps printed on their side utilizing 3 perimeters with 50% 3D cubic infill. Because they are printed on their side you may want to add support to the bridge inside of the clamp slots. I also printed the clamp block on the their side with 3 perimeters and 50% 3D cubic infill. The housing was printed with 2 perimeters and 25% rectilinear infill.

I am using these clamps for light clamping on a metrology fixture for measuring parts with a Faro Arm. If you intend to utilize these for higher clamping forces you may want to consider changing materials.