Large Middle-earth map.

"I will not say: do not weep; for not all tears are an evil." -J.R.R.Tolkien

Instructions: 

-please check each stl file size, it should be 200*200*2.24 mm. If not, resize in your slicer.

-i started the printing as it says below, and if you follow it, you should be ok, a print usually take 6 to 8 hours (on Bambu P1S combo), however, after the sixth or seventh plate i used the height range modifier as follows: layer range: 0-0.96, layer height 0.24, sparse infill density 100, wall loop 1. It reduces the printing time with -approximately- an hour, and i didn't saw any difference. After using the modifier the swaps changes, so you should always check the swaps, and look for the correct mm, not for the layer. 

After the print, i used superglue on a big paper sheet, glued them together, then i put the frame and hanged up the wall. 

Be prepared, this is a long project.

Update: in the original upload the 3_4 and the 3_5 stl file was the same, changed now for the correct ones. Thanks  @MatthewEastw_3865262 for the observation.

Printing:

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 1000x600mm in size

You may print at higher layer heights below the Base Thickness of 0.48mm

The Max allowed Thickness is 2.24mm and the Actual Thickness is 2.24mm

PLA BambuLab Matte Charcoal Transmission Distance: 0.6

PLA BambuLab Basic Pumpkin Orange Transmission Distance: 5.5

PLA BambuLab Basic Sunflower Yellow Transmission Distance: 4.4

PLA BambuLab Basic Beige Transmission Distance: 8

This print uses 4 unique filaments

Swap Instructions:

Start with Black

At layer #15 (1.28mm) swap to Pumpkin Orange

At layer #17 (1.44mm) swap to Sunflower Yellow

At layer #18 (1.52mm) swap to Beige for the rest.

Happy printing!