Revo Six Nozzle Holder MMU

This is a redesign of a popular Revo Six nozzle holder. It was drawn from scratch, but I still consider it to be a remix of E3D's popular holder.

The front of the model is wider to allow nozzle sizes to be printed, and the top is sloped so they can be read. The holder will fit on the frame of the printer on either the left or the right side of the MMU.

The bodies are named to help with filament selection in PrusaSlicer. The bodies named Yellow, Red, Blue, and Green refer to the nozzle size numbers. The bodies name E3D and Revo Six refer to the text on the front of the model. 

If you prefer E3D and Revo Six to be printed in something other than yellow, red, blue, or green, you can do so by pausing the print near 20mm height and do a manual filament swap. 

Printing

Printed at 0.1mm layer height using the 0.25 R6 nozzle and requiring 822 filament changes. The part was printed with a brim to assist in adhering the thin front face to the bed. No supports were used. 

If you use the attached g-code, the filament order should be black, red, yellow, blue, and green. Print time is roughly 26 hours.