yoyo bearing finger spinner

This was designed in early 2017 and posted to Thingiverse.com.  Only just now getting around to moving it over here.

finger spinner designed to use a yoyo bearing as the spinner, while still using regular skate bearings for weight.

required bearings
3x 608 skate bearings (22x8x7)mm
1x size C yoyo bearing (12.7x6.3x4.7)mm (1/4" x 1/2" x 3/16")in

Print instructions

Category: Toys & Games Print Settings

Printer: New Matter Mod-t

Rafts: No

Supports: Yes

Resolution: 0.1

Infill: 100%

Post-Printing

could use a little sanding to remove left-over support material

How I Designed This

designed in Fusion360. I'm new to Fusion and 3d modeling in general so this little project was very helpful in getting my feet wet and learning the basic concepts.