Display board for CS:GO pins

This is a 240x178x12mm wall mounted display board fitting all 11 of your Cs:go series 1 pins. (It probably works for other pins as well, idk)

This was designed for the “0.30mm Draft” profile in Prusaslicer, I just increased the wall count a bit on mine to make it more sturdy.

I recommend printing the “hole test" piece first before you commit to the whole print to check if your pins fit nicely into the holes. If it's too tight or too loose, try adjusting your extrusion multiplier to get it to fit.

Have fun printing!