Ford FITS LP Cupholder With Cable Mount (2022 Ford Maverick)

This is remix of the low profile cupholder done by RedBaron97. I added a 3M cable grabber onto the flat section I added between the cupholder holes so I could route a cable for charging an android tablet / phone on the road. I printed this on a Creality Ender 3 with eSUN PETG using the following settings:

Print Temperature: 245

Plate Temperature (Initial Layer): 80

Plate Temperature: 70

The rest of my settings were autoapplied via the eSun Black PETG with 0.4mm nozzle extruder settings in Cura 4.13.

Print time total was 9 hours 25 minutes.

Fitment was tested in rear center console slot.

Original Model: https://www.thingiverse.com/thing:5121962

Print Settings

Printer Brand:

Creality

Printer:

Ender 3

Rafts:

Yes

Supports:

No

Resolution:

0.2

Infill:

20

Filament: eSun PETG Black, Orange