Ford FITS Cubby Hole Adapter V1 (2022 Ford Maverick)

This is an adapter designed to add a FITS slot to the cubby hole on the dash. I added a blank press fit plate to hide the space in the back and add some stiffness via press fitting against the walls. This is designed to be used with velcro tape on the back for added stability / pull resistance and will not fit correctly without it.  For sanity this is two pieces of interlocking Velcro, with one side on the rear of the cubby hole and the other on the back of the print. The easier way to apply is to stick them together, peel the tape off the side facing the cubby hole, and insert and hold for adhesion. This is designed to be used with no rubber insert. I printed this on a Creality Ender 3 with eSUN PETG using the following settings:

Print Temperature: 245

Plate Temperature (Initial Layer): 80

Plate Temperature: 70

The rest of my settings were autoapplied via the eSun PETG with 0.4mm nozzle extruder settings in Cura 4.13.

Print time total was 9 hours 51.

Fitment was tested in the cubby hole.

Print Settings

Printer Brand:

Creality

Printer: 

Ender 3

Rafts:

Yes

Supports: 

Yes

Resolution:

0.2

Infill: 

20

Filament: eSun PETG Black, Orange

Category: Automotive