Ford Maverick FITS Seat Bar (2022 Ford Maverick)

This is a bar with a FITS slot on it. This is designed to slot into the bag holders I made. I put a little screw on each end so it doesn't slide out - gonna add holes eventually. I printed this on a Creality Ender 3 with eSUN PETG using the following settings:

Print Temperature: 245

Plate Temperature (Initial Layer): 80

Plate Temperature: 70

The rest of my settings were autoapplied via the eSun PETG with 0.4mm nozzle extruder settings in Cura 4.13.

Print time total was 9 hours 11 minutes.

Fitment was tested in the seat hooks - snaps in as expected.

Print Settings

Printer Brand:

Creality

Printer:

Ender 3

Rafts:

Yes

Supports:

Yes

Resolution:

0.2

Infill:

20%

Filament: eSun PETG Orange