Anemometer - Low Friction Upright

Anemometer for wall mounting.

Instructions

Inspired by the other anemometers on thingiverse.

Easy to make - requires 1 x 8mm bearing - the pictured version was printed using the Replicator 2.

Print the following:

Anemometer Cup x 3 - using standard settings;

Anemometer Support x 1 - standard settings;

8mm Hub x 1 - standard settings;

55mm8mm Rod x 1 - 100% infill on standard;

WingNut 8mm x 1 - 100% infill on standard;

8mm Nut x 3 100% infill on standard;

The wind cups fit into the hub, the hub fits the 8mm rod with a wingnut at the top. The 8mm nuts secure the hub and the bearing, as pictured. It then simply fits into the main support and its ready to go.

Category: Outdoor & Garden