Improved Eryone Thinker SE Direct Drive mod BMG + E3Dv6

The biggest upgrade made to my 3d printer was to switch from stock hotend+extruder combo to a direct drive v6 setup, using the Eryone Thinker SE Direct Drive mod BMG + E3Dv6 (Including Volcano) project.

I was overall satisfied, if it wasn't for a number of issues I had:

• I don't need a cable tie support on the base plate, since I route my cables together with the filament (in a ptfe tube) towards the original eryone extruder position, for reasons
• the bltouch mount wasn't fitting well to the base plate
• the fan ducts have unneeded slopes which makes impossible to print them without supports underneat them
• I used longer bolts than needed for my hotend cooling fan, and I had to drill holes in the mount in order to avoid cracking the piece
• I couldn't easily attach the fan mounts using two bolts for each, since the fan would partially cover the lower one on each side

So I designed my upgraded version of this project, which solves all the above issues. In particular:

• removed cable tie support on the base plate entirely
• added a second slot that fits the bltouch mount to the base plate
• made the fan ducts flat on the easiest side to print
• added through holes for the hotend fan
• added a third hole for mounting the part cooling fans on each side

I really hope someone will find this project useful!