No-Support Remake of SAMLA Hanga

This is basically a remix of the SAMLA Hanga for storing filament in an IKEA SAMLA box.

The original design was all one piece and required a lot of support. With my settings in Cura the original took 9.5m and time of 1:50. Plus there was all that support material to clean up and mar the surface.

So I redesigned this in 2 pieces so that I could print it WITHOUT any support while still maintaining the strength and ease of install.

So print the Bottom 1/2 and top 1/2 twice laying them flat on the bed with NO Supports, then assemble as shown. The clip on part of the Hanga ensures that the pieces will stay in place without any gluing but you can glue if needed.

Sketchup files included if needed.

Print Settings

Printer:

Geeetech Full Metal Aluminum

Rafts:

Supports:

No

Resolution:

Infill:

20%

Notes:

Simply press the bottom part into the top part as shown and clip onto the SAMLA box. See original model for more info.