Deathclaw - Can Holder / Beer mug

Deathclaw - Can Holder

• Fits long EU cans with a capacity of 0.5L. You can also use my insert for 12oz or 330ml (slim) cans (link below)

• Recommended print settings: PLA, 0.2mm layers, 2walls, 8%gyroid, brim, Automatic (30°) tree support, It is necessary to set supports even under small overhangs and teeth.

• Remove the supports wisely, very carefully, and ideally with pliers. It is better to spend 5 minutes removing the supports than to have a ruined piece.

Here is the link to my model of the insert that you can use in 0.5L holders with your 12oz , or 330ml slim cans, and 10mm riser if you want better access to the top. They are scalable, so you can make them smaller or larger in your slicer.

https://www.printables.com/model/1322047-can-holder-riser-inserts-12oz-slim-330ml-scalable

Happy printing:)