Base for Manuel's stackable tea bag dispenser

I use this great model by Manuel, works well with most teabags I have.

But found it a bit difficult to grab the bags when the dispensers are on a shelf or on the kitchen worktop.
This base should make it a bit easier by raising the dispensers.

I used the top part of the original dispenser to keep the same design.
There are 1 to 4 units wide bases to keep the dispensers together.
(On my prints the interlock on the dispensers is not very strong, but that is probably due to printing with 0.6mm nozzle)

I printed in Prusament PETG Galaxy Black

Bart

I made a base out of the top part of the original model, and made versions to support 1 to 4 wide stacks.