Clipper 50mm x 40mm Cap Top

Very simple cap to create a replacement cap for UK Clipper cans. The original can was a 300ml can with a 50mm diameter. The retaining lip on the can was just 0.68mm larger than the standard 50mm, so added the extra space. I also found that the can was slightly too high for my shelf, so I reduced the height to fit (about 3mm). Fits perfectly on the two cans I printed for. If I need to print it again, I might add a pole on the inside to hold the adaptor, but I did not need it - I just use the naked spout on the can.