Agility Jump Cups (parametric)

Jump cups for making dog Agility jumps.

The included STL works nicely for 1-1/4" OD jump bars and should be a regulation cup size for just about any Agility organization, but it's parametric so you can (probably) adjust from anything between gerbil-sized and horse-sized jumps. Some work was done to make it possible to produce flexible jump cups, but I haven't tested.

Sept 27th update: added a version of a removable cup that uses a low-profile dovetailed mount. This can be either for safety (protruding jump cups can be dangerous) or to allow for variable bar sizes with the same set of jumps.

Also added ability to generate clip-on jump cups. Versions for 3/4" ID pipe and 2-1/4" OD pipe is included as STL's (I need those sizes).

Print Settings

Rafts:

No

Supports:

No

Resolution:

.2mm

Infill:

15%

Notes:

Printed in PLA, ABS and PETG without any problems. Clip-on cups should probably have support.

Post-Printing

Screw-in components should work with a standard #8 deck screw.